3/15/2024 0 Comments Unrealircd centos 7 install guide![]() Removed symlink /etc/systemd/system/default.target.Ĭreated symlink from /etc/systemd/system/default.target to /usr/lib/systemd/system/graphical.target. ~]# systemctl set-default graphical.target To do this, we must first set the graphical target to become the default. While this will start the graphical user interface by moving us into the graphical target (similar to run level 5), if we perform a reboot we will not be presented with the GUI. We can start the GUI right now ( as long as there is a GUI installed) by running ‘systemctl isolate graphical.target’. The multi-user.target is similar to the well known run level 3, which is essentially console only with networking enabled. With the systemctl command, we can list the default target that the system is configured to boot into. In this example I have installed CentOS 7 but we are not currently using the GUI. In this quick guide we will show you how to swap to the GUI and enable it to start up by default on system boot. By default a full installation of CentOS 7 will have the graphical user interface (GUI) installed and it will load up at boot, however it is possible that the system has been configured to not boot into the GUI.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |